Common Problems and Solutions for Centrifuges

Question 1: What should pay attention to in the placement of the centrifuge?

A: The centrifuge is generally placed in a dry, avoiding direct sunlight. The centrifuge is relatively large, and no stack of debris, surrounded by walls, baffles, etc., the heat dissipation is at least 10 cm or more. At the same time, the centrifuge is as separate as possible in a room, and it is very good to put an organic reagent and flammable.

Question 2: What maintenance should be paid to the centrifuge to extend service life?

A: Every time after using it, must open the centrifuge cover, so that heat or water is naturally evaporated. If you use a low temperature centrifugation, you may have ice, then you should melt, and wipe it with dry cotton yarn cloth. Wait until there is no obvious water vapor, cover the cover. If the centrifuge-head can be replaced, taken in time after each of it is used. And it is wiped with clean, dry medical gauze, and put it down, do not use the sharpening. Aluminum head should be cleaned frequently. The initial user should ask the person who used to use or as the reference manual, do not blindly use it.
 
Question 3: What should we pay attention to when the specific operation?
 
A: When we are using, you should pay attention from all aspects. After choosing a good head, after setting the parameters, you have to observe the centrifuge for a while, wait to reach the high speed, and the stable operation, it can be separated. If you hear an abnormal sound or smell odor, you should take the brake immediately, press the "Stop" button, and if necessary, cut off the power. The centrifuge tube is placed symmetrically, and the centrifuge tube corresponding to each other is equal to as much as possible. During the operation, it is forbidden to open the centrifuge cover! 

Question 4: What are the common accidents of centrifuge?

A: The common problem is: the cover does not open, the centrifuge can not be taken, the centrifuge does not work, more serious problems is the uneven force on the shaft causes bending the motor is burned, the horizontal bucket is taken out, etc.

Any requirements, contact us now!

Grace

Email:grace@filtrationchina.com

Mobile/Whatsapp/WeChat：+86 17269571160